Product ID:CENTARI ACRYLIC ENAMEL, WHITE, 817A(2/1/74)
MSDS Date:01/01/1985
FSC:8010
NIIN:00-546-8961
MSDS Number: BFDTY

E.I.DUPONT DE NEMOURS & COMPANY,INC.

1007 MARKET STREET
WILMINGTON, DE 19899
US

Emergency Phone: 800-441-7515

Info Phone: 800-441-7515

Cage: DO229

E.I.DUPONT DE NEMOURS & CO INC

1635 BOSTON, MA 02118 US

Telephone: 800-441-7515

Cage: DO229

ALIPHATIC PETROLEUM DISTILLATE(ANALOG TO HEPTANE & OCTANE)

Fraction By Weight: 12.0%

ACGIH TLV: 100PPM(PER MFR)

ALIPHATIC KETONE

Fraction By Weight: 4.0%

ACGIH TLV: 1000PPM(PER MFR

AROMATIC PETROLEUM DISTILLATE(ANALOG TO XYLENE)

Fraction By Weight: 9.0%

ACGIH TLV: 100PPM(PER MFR)

TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 10.0%

OSHA PEL 200 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

XYLENES (O-,M-,P- ISOMERS) (SARA III)

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 16.0%

OSHA PEL 100 PPM/150 STEL

ACGIH TLV: 100 PPM/150STEL;9192

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

Effects of Overexposure:CAUSES HEADACHE,NAUSEA,IMPAIRMENT OF REACTION
TIME AND COORDINATION.

First Aid:INHALATION:MOVE TO FRESH AIR TO IMPROVE BREATHING;SKIN:WASH
WITH SOAP & WATER.REMOVE CONTAMINATED CLOTHING;EYES:FLUSH WITH
WATER FOR AT LEAST 15 MIN.CALL A PHYSICIAN.

Flash Point:20-80F (T.O.C)
Lower Limits:1.0
Upper Limits:12.8
Extinguishing Media:CO*2, FOAM, DRY CHEM.
Fire Fighting Procedures:COOL CLOSED CONTNRS W/H*2O USING FOG NOZZLES.

Spill Release Procedures:EVACUATE UNPROTECTED PERSONS. ELIM IGNITION
SOURCES. STOP LEAK. H*2O SPRAY COOL CONT/DIVERT SPILL FROM
FIRE/HEAT. PROVIDE VENTILATION. ABSORB W COMMERCIAL
ABSORBENT,SHOVEL INTO METAL DRUMS:LG SPILL:DI KE W COMMERCIAL
ABSORBENT,PUMP INTO COVERED DRUMS.

Handling and Storage Precautions:KEEP AWAY FROM HEAT,SPARKS & OPEN
FLAMES.CLOSE CONTAINERS AFTER EACH USE.DO NOT STORE ABOVE 120F
Other Precautions:WASH THOROUGHLY AFTER HANDLING AND BEFORE EATING OR
SMOKING;OBSERVE LABEL PRECAUTIONS;CONTAINERS SHOULD BE GROUNDED
WHEN POURING;USE NON-SPARKING TOOLS WHEN REMOVING SPILLED MATL.

Respiratory Protection:USE CARTRIDGE-TYPE RESP IAW MFR DIRECTIONS IF
AIR CONTMNT UNCONTRLAB
Ventilation:LOCAL & MECH PROVIDE SUFFICIENT VENT TO KEEP BELOW TLV
LEVEL
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY/CHEM GOGGLES
Other Protective Equipment:USE APPROPRIATE INDUSTRIAL HYGIENE
PRACTICES.
Supplemental Safety and Health
MSDS FM MFR DATED:02/01/74;ALSO CONTAINS: 0.15% LEAD FROM DRIER,TLV
0.15 MG/CUM; VAP DENSITY/PRESSURE NOTED OF PRINCIPAL SOLVENT.

HCC:F3
Boiling Pt:B.P. Text:131-437F
Vapor Pres:10
Vapor Density:3.66
Spec Gravity:1.050
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:MODERATE
Appearance and Odor:WHITE SEMI-VISCOUS LIQUID;MODERATE SOLVENT.
Percent Volatiles by Volume:63.8

Stability Indicator/Materials to Avoid:YES
OXIDIZERS, CORROSIVES
Stability Condition to Avoid:HEAT, IGNITION SOURCES
Hazardous Decomposition Products:CO,CO*2,SMOKE,OXIDES OF LEAD

Waste Disposal Methods:KEEP IN COVERED DRUMS,PENDING DISPOSAL. HANDLE &
DISPOSE IN FULL COMPLIANCE WITH ALL APPLICABLE
INTERNATIONAL,FEDERAL,STATE, & LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.